Raspberry Pi Compute Module IO Board with PoE Feature, for Raspberry Pi CM3 / CM3L / CM3+ / CM3+L

Description
The Compute Module PoE Board is a development board that you can plug a Raspberry Pi Compute Module into, and make use of the resources of Pi more flexibly. With the PoE (Power over Ethernet) feature, and versatile onboard peripheral interfaces, it is suitable for evaluating the Raspberry Pi compute module, also is an ideal choice for end products.

Key Features
Raspberry Pi GPIO header, for connecting sorts of Raspberry Pi HATs
10/100M auto-negotiation Ethernet port, with PoE, enabled
4x USB ports allow connecting more USB devices
2x CSI camera interfaces
Onboard HDMI / DSI interfaces for connecting displays
Onboard USB TO UART, for serial debugging
Cooling fan interface, autorun on power-up OR controlled by IO pins
Adopts isolated SMPS (Switching Mode Power Supply)
Specifications
Power supply: micro USB port / PoE Ethernet port
PoE power input: 37V ~ 57V DC-in
PoE power output: 5V 2.5A DC out
Network standard: 802.3af PoE standard
Dimensions: 114mm ¡Á 84.4mm
Mounting hole size: 3.2mm
Whats on Board
1. Compute Module interface: for connecting Compute Module (CM3 / CM3L / CM3+ / CM3+L)
2. Raspberry Pi GPIO header: for connecting Raspberry Pi HATs
3. PoE enabled Ethernet port: 10/100M auto-negotiation, for connecting router or switch with PoE function
4. DSI interface: display ports, for connecting Raspberry Pi LCD
5. USB ports: 4x USB ports, for connecting USB devices
6. CSI interface: 2x CSI camera ports, for connecting Raspberry Pi Camera
7. HDMI port
8. USB TO UART interface: for serial debugging
9. USB SLAVE interface: allows you to burn system image into Compute Module 3/3+
10. Power port: 5V 2.5A
11. TF card slot (bottom side): insert a Micro SD card with the pre-burnt system, to start up Compute Module 3/3+ Lite variant
12. Cooling fan interface
13. LAN9514 (bottom side): fully-integrated USB hub and 10/100M Ethernet controller
14. Si3404 PoE power management chip (bottom side)
15. CP2102 USB TO UART converter
16. EP13 PoE power transformer
17. Optical isolator
18. Two LED indicators:
19. Red: Raspberry Pi power indicator
20. Green: Raspberry Pi operating status indicator
21. NET network indicator
22. VGx power config jumper: config the I/O level
23. UART output config:
24. Left: connect the CP2102 serial port and Raspberry Pi serial port
25. Right: disconnect the CP2102 serial port and Raspberry Pi serial port
26. Cooling fan config:
27. P34: the fan is program-controlled via P34 pin
28. EN: the fan is directly powered from 5V power supply
29. PoE config:
30. DIS: disable PoE
31. EN: enable PoE
32. PoE power voltage measuring pads
Example

Note
Compute module in the photo is NOT included.
Dimensions

Part List
Compute Module PoE Board x1