PYNQ Z2 board - based on Xilinx Zynq C7Z020 SoC

TUL PYNQ -Z2 board, based on Xilinx Zynq SoC is designed for the Xilinx University Program to support PYNQ (Python Productivity for Zynq) framework and embedded systems development.
PYNQ is an open-source project from Xilinx that makes it easy to design embedded systems with Xilinx Zynq Systems on Chips (SoCs).
Using the Python language and libraries, designers can exploit the benefits of programmable logic and microprocessors in Zynq to build more capable and exciting embedded systems.
ZYNQ XC7Z020-1CLG400C
650MHz dual-core Cortex-A9 processor
DDR3 memory controller with 8 DMA channels and 4 High-Performance AXI3 Slave ports
High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
Low-bandwidth peripheral controller: SPI, UART, CAN, I2C
Programmable from JTAG, Quad-SPI flash, and MicroSD card
Programmable logic equivalent to Artix-7 FPGA
13,300 logic slices, each with four 6-input LUTs and 8 flip-flops
630 KB of fast block RAM
4 clock management tiles, each with a phase locked loop (PLL) and mixed-mode clock manager (MMCM)
220 DSP slices
On-chip analog-to-digital converter (XADC)
Memory
512MB DDR3 with 16-bit bus @ 1050Mbps
16MB Quad-SPI Flash with factory programmed 48-bit globally unique EUI-48/64 compatible identifier
MicroSD slot
Power
Powered from USB or 7V-15V external power source
USB and Ethernet
Gigabit Ethernet PHY
Micro USB-JTAG Programming circuitry
Micro USB-UART bridge
USB 2.0 OTG PHY (supports host only)
Audio and Video
HDMI sink port (input)
HDMI source port (output)
I2S interface with 24bit DAC with 3.5mm TRRS jack
Line-in with 3.5mm jack
Switches, Push-buttons, and LEDs
4 push-buttons
2 slide switches
4 LEDs
2 RGB LEDs
Expansion Connectors
Two standard Pmod ports
16 Total FPGA I/O (8 shared pins with Raspberry Pi connector)
Arduino Shield connector
24 Total FPGA I/O
6 Single-ended 0-3.3V Analog inputs to XADC
Raspberry Pi connector
28 Total FPGA I/O (8 shared pins with Pmod A port)